Koolance PC3-420SL Manuel d'utilisateur télécharger pdf (Page 15)

10 Filling & Maintenance

CAUTION: Jumping the incorrect ATX power supply pins can cause

permanent damage to the power supply.

Your Koolance system is designed to automatically filter air from the liquid. Before

filling, the cooling system should be “jump-started” to assist in the circulation pro-

cess.

Make sure the AC power cord is attached to the power supply. If the power supply has

a rear switch, it must be in the ON (-) position. Using the ATX Jumper Wire, insert the

metal prongs into pin numbers 4 and 6 on the 20-pin motherboard ATX power supply

connector (green and a black ground wire-- See diagram).

Testing & Filling

You should now hear the pumps running in an empty

reservoir.

The large, slot-headed refill tap is located above the

reservoir. Remove it with a flat screw driver.

With the reservoir open, insert the refill funnel.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 21 22

Pas de commentaire

Koolance PC3-420SL Manuel d'utilisateur Page 15