Koolance PC2-901BW Manuel d'utilisateur télécharger pdf (Page 46)

41User Manual

CAUTION: Jumping the incorrect ATX power supply pins can cause

permanent damage to the power supply.

Your Koolance system is designed to automatically filter air from the liquid. Before

filling, the cooling system should be “jump-started” to assist in the circulation pro-

cess.

Make sure the AC power cord is attached to the power supply. If the power supply has

a rear switch, it must be in the ON (-) position. Using the ATX Jumper Wire, insert the

metal prongs into pin numbers 4 and 6 on the 20-pin motherboard ATX power supply

connector (green and a black ground wire-- See diagram).

Testing & Filling

You should now hear the pumps running in an empty

reservoir.

The refill tap is located beneath the case. Turn the

system upside-down and remove the large slot-headed

screw.

With the system upside-down, insert the refill funnel.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 52 53 54

Pas de commentaire

Koolance PC2-901BW Manuel d'utilisateur Page 46